Nippon Golf Shafts - N.S. Golf Shaft Standard Trimming Specifications

Have Your Golf Clubs Custom Built

NO EXTRA CHARGE

More Details

HERE

Debit and credit card payments accepted via

Golf Technology Limited

Unit 1 Pipewell Road,

Desborough,

Northants NN14 2SW

Phone:

01536 760630

Email:

info@golftechnology.co.uk

N.S. Golf Shaft Standard Trimming Specs

When re-shafting, be sure to observe the standard trimming specifications shown in the table below to ensure that the shaft's original characteristics are maintained to the fullest.

• Tip trim shows the length that can be cut off from the shaft tip. If it is 0, trimming should be done from the shaft butt (grip side) only.

• First, cut off the tip by following the specifications shown in the table on the right. Then attach the club head and cut from the butt to the standard club length.

• The table shows recommended trimming specifications. You may custom-trim to adjust flex according to your personal preferences. However, excessive trimming that significantly exceeds the specified lengths may degrade the strength of the shaft.

• Wood shafts do not support through bores, but can be directly used with blind-bore heads. (Using through bores will cause the shaft to harden slightly.)

Custom fitted, custom fit golf clubs, golf clothing, shafts, grips, heads and accessories from Adidas, Ashworth, Glenmuir and Cutter & Buck, Nipon and SK Fibre - Northamptonshire Leicestershire